Difference between revisions of "Cheetah1 SDK v1.16 Known Issue"
(创建页面，内容为“Cheetah1<br/> <br/> '''1. 不支持常见的串口波特率38400。下一版本会支持。'''<br/> 有一个补丁可以增加。<br/> \\192.168.1.88\RoseekShare\RO…”) |
|||
| Line 1: | Line 1: | ||
Cheetah1<br/> | Cheetah1<br/> | ||
<br/> | <br/> | ||
| − | '''1. | + | '''1. The serial port baud rate of 38400 is not supported. The next version will be supported.'''<br/> |
| − | + | There is a patch that can be added.<br/> | |
\\192.168.1.88\RoseekShare\ROSEEK_WebUseFullSDK\Cheetah1_cn\v1.16.00_20170712_patch_1 | \\192.168.1.88\RoseekShare\ROSEEK_WebUseFullSDK\Cheetah1_cn\v1.16.00_20170712_patch_1 | ||
| − | '''2. Roseek_MediaEncoder_InitParamsV1 | + | '''2. The Roseek_MediaEncoder_InitParamsV1 fuction is not in the document.'''<br/> |
| − | + | This function uses a new parameter data structure and adds some configuration items.<br/> | |
| − | + | Temporarily, these configuration items are not enabled, so there is no need to additional configuration.<br/> | |
| − | + | You can use the Roseek_MediaEncoder_InitParams or use the Roseek_MediaEncoder_InitParamsV1, the effect is the same.<br/> | |
| − | |||
| − | '''3. Linux | + | '''3. The Linux serial port cannot be used immediately when it is started. It takes about 1 minute to use.'''<br/> |
| − | + | In current and previous versions, we found that a service can affects the serial port.<br/> | |
| − | + | It is recommended that you manually configure this service to be down. The command is:<br/> | |
| − | |||
sudo systemctl disable ModemManager.service<br/> | sudo systemctl disable ModemManager.service<br/> | ||
| − | 1. | + | The 1.17 version of the SDK will automatically execute this command during installation to fix this problem.<br/> |
Revision as of 02:06, 30 October 2018
Cheetah1
1. The serial port baud rate of 38400 is not supported. The next version will be supported.
There is a patch that can be added.
\\192.168.1.88\RoseekShare\ROSEEK_WebUseFullSDK\Cheetah1_cn\v1.16.00_20170712_patch_1
2. The Roseek_MediaEncoder_InitParamsV1 fuction is not in the document.
This function uses a new parameter data structure and adds some configuration items.
Temporarily, these configuration items are not enabled, so there is no need to additional configuration.
You can use the Roseek_MediaEncoder_InitParams or use the Roseek_MediaEncoder_InitParamsV1, the effect is the same.
3. The Linux serial port cannot be used immediately when it is started. It takes about 1 minute to use.
In current and previous versions, we found that a service can affects the serial port.
It is recommended that you manually configure this service to be down. The command is:
sudo systemctl disable ModemManager.service
The 1.17 version of the SDK will automatically execute this command during installation to fix this problem.
